470017
23
Verklein
Vergroot
Pagina terug
1/25
Pagina verder
FISH 4100 Installation and Operation Manual NAVMAN
23
To stop problems from electrical noise, try:
- rerouting the power and transducer
cable(s) away from the boat’s other
electrical wiring.
- routing the unit's power cable directly to the
battery instead of through a fuse block or
ignition switch.
4. Bottom is not displayed:
a) The fishfinder may have Manual Range
selected and the depth may be outside the
range value selected. Either change the
fishfinder to Auto Range or select another
depth range - see section 3.8.
b) The depth may be outside the fishfinder’s range.
While in Auto Range, the display unit will flash
the last depth displayed, then display “--.-” to
indicate that there is no bottom detected. A
display of the bottom should reappear when it is
shallower than 180m (600ft).
5. The bottom is displayed too far up the screen:
The fishfinder may have Manual Range
selected and the selected Range value is too
high for the depth. Either change the fishfinder
to Auto Range or select another depth range -
see section 3-8.
6. Bottom echo disappears or erratic digital
reading while the boat is moving:
a) Ensure the back of the bottom surface of the
transducer is slightly lower than the front and
the front is as deep in the water as possible in
order to minimize the generation of bubbles
through cavitation. See the Transducer
Installation Guide for more information.
b) The transducer may be in turbulent water. Air
bubbles in the water disrupt the echoes
returned, interfering with the fishfinder’s ability
to find the bottom or other targets. This often
happens when the boat is reversed. The
transducer must be mounted in a smooth flow
of water in order for the fishfinder to work at all
boat speeds.
c) Electrical noise from the boat’s motor can
interfere with the fishfinder. Try some
suppression spark plugs.
7. If the fishfinder beeps when turned on but
nothing is displayed:
The fishfinder may be operating, but the
contrast settings may have been set too high
or low. Power off the fishfinder. Then hold
and press to reset the fishfinder to the
default contrast setting.
8. The wrong language is displayed:
See section 2.
9. The message "NO TRANSDUCER DETECTED.
ENTER SIMULATION MODE?" appears when you
turn the unit on:
a) Check to see that the blue transducer
connector is plugged into the top connector
(with the blue nut) on the rear of the display
unit.
b) Check the cable connectors are securely
plugged in and the blue collars are is locked in
place. The collars must be secure for water
tight connection.
c) Check that the plugs are clean and free of
water or anything that may short deteriorate the
quality of the connection. Inspect the
transducer cable from end to end for damage
such as cuts, breaks, stretched or squashed
sections.
23

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Navman FISH 4100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Navman FISH 4100 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,22 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Navman FISH 4100

Navman FISH 4100 Gebruiksaanwijzing en installatiehandleiding - Nederlands - 25 pagina's

Navman FISH 4100 Gebruiksaanwijzing en installatiehandleiding - Deutsch - 27 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info