809288
3
Verklein
Vergroot
Pagina terug
1/9
Pagina verder
EN
3
B. Mounting the speaker in the dock
1. Pull the handle out.
Pull
2. Rest one corner of the speaker on the dock at a slight angle to
get the speaker seated.
3. Rotate the speaker until it is completely in place in the dock.
4. Release the handle to finish securing in place.
NOTE: It will be easiest to connect the wire harness before mounting
the speaker in the dock.
C. Power and Ground Connections in the
vehicle
18" (46cm)
Chassis ground (–)
Remote turn-on (blue)
to stereo REM out
Battery
Fuse holder, 20A fuse
i. Power: Connect the red +12V power wire in the wire harness
to the positive terminal of the vehicle battery. Install a 20A fuse
and fuse holder within 18" (457mm) of the battery.
ii. Ground: Connect the black GND wire in the wire harness to
bare metal of the vehicle’s chassis, such as at a seat belt bolt.
NOTE: If possible, remove any paint from the chassis for best contact.
It is recommended to use a star washer below the ring connector for a
secure connection.
iii. Remote-In: Connect the blue remote turn-on wire in the wire
harness to the “Remote Out” lead of the source unit, if using
low-level signal inputs.
NOTE: 12V ACC turn-on is the preferred method. If you are using
high-level signal inputs (vehicle speaker wires), you can choose to have
the DC offset feature or the audio-sensing feature turn the amplifier on.
You will not have to connect the remote turn-on wire and can terminate
the connection.
D. Power/Protect indicators when connected to
the vehicle
The power button on the control panel indicates the
speaker’s modes of operation.
Illumination color Mode of operation
White Subwoofer mode (in vehicle only)
Green Full-range mode
Red
Protect mode (over/under voltage/short
circuit/amplifier circuit failure/excessive
heat)
Yellow Settings mode
E. Signal input in the vehicle
Line-level inputs: If your source unit offers preamp outputs,
connect them to the RCA inputs in the wire harness. Use front
or rear preamp outputs for full-range operation, or subwoofer
preamp outputs (if available) for subwoofer mode.
12V DC AUDIO
2V 4V 6V
Note: When using low-level signals and remote turn-on lead, set the
“Auto Turn-on” switch to “12V,” and set the speaker’s input level to “LO”
in the settings menu (see “setting the input level”). Set the “Auto-on”
switch to 2V, 4V, or 6V, whichever most closely matches the voltage of
your source unit’s preamp outputs.
High-level inputs: If your source unit does not have line-level
outputs, use the supplied high-level input adapters to connect to
the speaker output wires of your source unit to the RCA inputs in
the wire harness.
Loosen
Screws
Insert
Wires
Tighten
Screws
12V DC AUDIO
NOTE: When using high-level signals, set the “Auto Turn-on” switch to
“DC” (to turn on when it receives battery power) or “AUDIO” (to turn on
when it senses audio signal). Set the input level to “HI1” in the settings
menu (see “setting the input level”). If no sound plays, change the input
level to “HI2”.
F. Connecting the remote bass control in the
vehicle
Plug the remote bass controller into the appropriate input in the
wire harness. Mount the remote in a convenient location, such as
under the dash, using sheet metal screws.
Turn the dial clockwise to increase the bass output, and
counterclockwise to decrease the bass output.
NOTE: Remote bass control will only operate in subwoofer mode.
JBL BassPro Go_owners manual_SOP_V6.indb 3JBL BassPro Go_owners manual_SOP_V6.indb 3 11/23/2020 5:52:59 PM11/23/2020 5:52:59 PM
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JBL BassPro Go bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JBL BassPro Go in de taal/talen: Engels als bijlage per email.

De handleiding is 11.53 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van JBL BassPro Go

JBL BassPro Go Gebruiksaanwijzing - Nederlands - 9 pagina's

JBL BassPro Go Gebruiksaanwijzing - Deutsch - 9 pagina's

JBL BassPro Go Gebruiksaanwijzing - Français - 9 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info