479858
3
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
ALARM MEMORY
When disarming the alarm, if five turn signal flashes and five beep signals
occur (if this function have not be excluded in programming stage), it is
possible to identify the cause generating the alarm condition.
To do this, turning the ignition key in “ON” position and see at the vehicle
installed LED.
The LED will be blink, shown the last alarm condition.
The cause of the alarm will indicate for 5 times.
This indication can be interrupted by turning the ignition key to OFF.
The possible alarm signalling are indicated in the under table.
GARAGE FUNCTION
This function is used when the alarm disarming is required, e.g. for
maintenance, without any intervention to the previous programming.
In fact, this function disarms completely the alarm, without any intervention
when passive arming and against absent-mindedness arming are
programmed.
To do this, proceed as follows:
! With the alarm system deactivated, turn the ignition key to “ON” position
! The status LED will turn on for approximately 0.5”.
! During this period, put the electronic key in the specific receptacle.
! The led is turned off to indicate the alarm de-activation.
! To restore normal operating of programmed functions, arm the alarm via
the radio control.
PAG. 4
PAG. 5
PROGRAMMABLE FUNCTIONS
ACOUSTIC SIGNALS
PANIC ALARM OR CAR-FINDER
If enabled, the PANIC ALARM function allows the user to activate the visual
and audio alarm signals deliberately by pressing key 2 on the remote.
This function works regardless of whether the alarm system is “ON” or “OFF”.
The alarm signal lasts up to approx. 30”. However, you can silence it at any
time by pressing key 2 on the remote again
While the alarm signal is emitted the LED emits a continuous light.
If during the programming phase, the PANIC function has been disabled, the
CAR FINDER function will be activated.
When the alarm is activated, the CAR FINDER function allows you to obtain a
short optic/acoustic signal by pressing button N°2 on the remote.
TThis function can be useful to look for the car in a parking lot or parking silo
without creating useless alarm condition.
The brief optic/acoustic signal consists of a low beep and the simultaneous
flashing of the turn indicators.
NOTE: the emission of the audio signals is subordinate to their being enabled
when programming the accessory functions.
CURRENT ABSORPTION SENSOR
ANTI-DISTRACTION FUNCTION AND DOOR LOCKING
This function determines the automatic activation of the system if this has been
disarmed and no voluntary actions are performed by the user (e.g. Door
opening).
The function prevents the vehicle from being left unprotected in cases where,
after the arming of the system, this is turned OFF accidentally by pressing the
button N°1 of the remote control.
The self rearming is confirmed by the alarm with visual/acoustic signalling (one
flash by the turn signals and one acoustic signal) .
The anti-distraction function activates the CDL control.
Therefore, in order to prevent involuntary activations of the system, it's
MANDATORY to connect the door pin switch to the system input
(BROWN/GREN wire of the alarm wiring harness).
This function allows the user to permanently exclude all acoustic signals.
See the relative paragraph for programming.
ATTENTION: before activating of the absorption sensor, it is suggested
to consult the specific rules being in force in your country (noise
pollution).
When the absorption sensor is activated, a signal will be sent out at any
minimal tension variation in the vehicle's electrical circuit (for example lamp
switching on).
NOTE: after disarming, a door opening will stop the function.
Together with the previously described function, the automatic door locking of
the vehicle is done when running.
LED SIGNAL
CAUSE OF THE ALARM
NUMBERS OF
ALARM CYCLES
5
Infinite
5
Infinite
5
5
Absorptions sensor
Doors switches
Cut wires
Positive under key (+15/54)
Trunk, hood and volumetric
sensor
External magnetic contact
LED ON (400mS)LED OFF (2 seconds)
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gemini 7563 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gemini 7563 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,27 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info