761232
2
Verklein
Vergroot
Pagina terug
1/160
Pagina verder
2
GB
ROI
IN
MT
JM
PH
SG
LOOKING AFTER YOUR HAND DRYER
WARNING
This product is not to be used in sinks where a plug is fitted. Before engaging the water
flow ensure that the plughole is clear of any obstructions and that water can drain freely.
HOW TO USE
Place your hands beneath the Dyson hand dryer and it will automatically, creating sheets of air
to scrape water from your hands.
For best dry time results:
Keep your hands flat and parallel to the appliance surface, approximately 5 mm from the
blade, drawing your hands through the airflow from your wrists to finger tips.
Move your hands slowly through the airflow keeping a consistent speed, approx. 2.5 seconds
per side, alternating between front and back each time.
Keep you hands flat, close the gaps between your fingers and keep your thumbs in to ensure
that the whole of your hand is drawn through the airflow.
TROUBLESHOOTING GUIDE
WARNING: RISK OF ELECTRIC SHOCK!
Problem Action
The hand dryer fails to start. Check that the fuse/circuit breaker is working
and that the power is connected. Must be
performed by a qualified electrician.
Ensure that the cleaning cap is removed and
that the sensors are clean and unobstructed.
If a safe method of switching is available,
turn the unit on and off. If a safe method is
not available, a qualified electrician must
perform this task.
The hand dryer is turning on and
off erratically. Ensure that the sensors are clean and free
from obstructions.
Check that the sensor cable from the tap is
securely connected. Must be performed by a
qualified electrician.
The hand dryer sometimes cuts out when
in use but resumes operation after a period
of time.
Check that the air inlet is clean and free
of dust.
Remove any dust from the air inlet.
Ensure that the air inlet is free from
obstructions and has sufficient clearance
(see installation instructions).
The dry time of the hand dryer has increased. Inspect the inlet grille for dust and remove.
Inspect the filter and change if required.
Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
Must be performed by a qualified electrician.
NOTE: Ensure water feed is completely flushed of debris, copper filings etc. prior to
connecting to the product. Failure to do so will damage the solenoid valve.
The instructions in this manual and the installation guide must be followed completely,
as failure to do so may result in incorrect operation, damage to property and/or
personal injury. It is recommended that an isolation valve is fitted with this product
during installation. Dyson will not be held liable for any damage to property or
personal injury, or any loss of business or revenue, if you, your staff, your installer
or service engineers have not followed the instructions given in this manual and the
installation guide.
27.11.2017 12:51 - C92757_WD04_OPMAN_INT_X588-OWNERS-MANUAL-PART 3- TEXT.indd_15_0c2s_15_0c2s
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dyson Airblade Wash and Dry WD05 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dyson Airblade Wash and Dry WD05 in de taal/talen: Alle talen als bijlage per email.

De handleiding is 3,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Dyson Airblade Wash and Dry WD05

Dyson Airblade Wash and Dry WD05 Aanvulling / aanpassing - English - 1 pagina's

Dyson Airblade Wash and Dry WD05 Aanvulling / aanpassing - Alle talen - 4 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info