465521
3
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
3
Fig. 15
Fig. 13
110 mm
minimum from
nearest
obstruction
60 mm
fixing
centres
Fig. 14
t
s
INSTALLATION INSTRUCTIONS
NEW INSTALLATION
Choose a fixing position where the TP5E will sense the
room temperature without being affected by draughts or
heat sources such as radiators, open fires of direct
sunlight, see fig. 13. Fix at a height of approximately 1·5
metres from the floor. Cable entry is from behind if fitted
to a single gang flush box; or from above, below or from
the left if surface fixed cabling is used. Fig. 14 shows the
fixing hole dimensions and the clearance required for
removal of the sliding battery cover. Standard M3·5
screws are used to fix the TP5E to a flush box, or No.6
woodscrews and wallplugs of adequate length should be
used for surface fixing.
REPLACING AN ORDINARY ROOM THERMOSTAT
Switch OFF the power supply to the heating system.
Carefully note which wire colours are connected to which
terminal numbers of the existing thermostat, and note the
function of each terminal. If the existing thermostat has
no indication of the function of each of its terminals, then
a qualified electrician should be called before proceeding
further.
Remove the existing thermostats mounting plate from
the wall, if applicable, and prepare the wall to receive the
TP5E. Refer to fig. 14 for dimensions. Connect the wires
to the TP5E as shown in fig. 15.
If the existing wires are too short to connect to the TP5E
then a pattress (PT05) should be fixed to the wall and
used to terminate the existing wiring. New wires can then
be extended from the pattress to the TP5E, which can
then be fixed to the pattress with the screws provided.
NOTE. Some existing thermostats will have a Neutral
wire and/or an Earth wire connected. These are not
required by the TP5E and must not be connected to any
TP5E terminals, but should be made electrically safe and
coiled in the recess at the back of the TP5E. If in doubt
about the function of any existing wire, call a qualified
electrician for advice.
Selecting the control mode
The TP5E can operate either in on/off control mode or
in chrono-proportional control mode. This is selected
by means of a small link on the rear of the product
(see fig.15 for location)
The unit is factory set to on/off control with the link in
place. When in on/off mode the thermostat cycles the
heating on and off within its switching differential. If
chrono-proportional control is selected the thermostat
learns and attempts to reduce the switching differential
thus improving comfort.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Danfoss-TP5E

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Danfoss TP5E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Danfoss TP5E in de taal/talen: Engels als bijlage per email.

De handleiding is 0,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Danfoss TP5E

Danfoss TP5E Gebruiksaanwijzing - Nederlands - 2 pagina's

Danfoss TP5E Gebruiksaanwijzing - Français - 1 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info